ThinkPad X60 Tablet recovery

Only the Intel GPU is compatible. Do not flash the ATI GPU models.

“Unbricking” means flashing a known-good (working) ROM. The problem: you can’t boot the system, making this difficult. In this situation, external hardware is needed which can flash the SPI chip (where libreboot resides). First, disassemble the machine using the following steps, and refer to the external flashing guide linked later from this guide.

Remove those screws:

Remove the HDD:

Push keyboard forward to loosen it:

Lift:

Remove those:

Also remove that (marked) and unroute the antenna cables:

For some X60T laptops, you have to unroute those too:

Remove the LCD extend board screws. Also remove those screws (see blue marks) and remove/unroute the cables and remove the metal plate:

Remove that screw and then remove the board:

This photo shows the flash location:

This photo shows an SPI flasher used, with SOIC8 test clip:

Refer to the external flashing guide:

Externally rewrite 25xx NOR flash via SPI protocol

NOTE: Do not use the 3.3v rail from your SPI programmer. Leave that disconnected. For 3.3v, plug your charger into the motherboard (but do not power on the mainboard) when the clip is connected. Before removing the clip, disconnect the charger. This will provide adequate 3.3v DC at correct current levels. The SPI flash on an X60 Tablet shares a common 3.3V rail with many other components on the motherboard, which all draw a lot of current, more than most flashers can provide.

Reverse the steps to re-assemble your system, after you’ve flashed the chip.